Kant press Stegherr.
Protective, large-area clamping of the workpieces. Maximum edge pressing pressure. Equalised pressure through swing suspension oscillating of pressing bar. Modern, compact construction. Stegherr kant press edge bander is equipped with special pressure hoses instead of the customary cylinders affected by lateral pressures. The swinging and self adjusting pressure bar is adapted to unevenness on the workpiece.
The patented continious clamping bar permits simultaneous processing of workpieces of different size without re-setting the edge bander.
The edges are aligned with the surface by two quickly adjustable fnces. The edge can be set flush at the front or rear, centraly or with a different projection.
Veneer and plastic lippings are glued with PVAc white glue in 20 sec. This high output is achieved by the thermostatically controlled heating bar and the extremely high edge pressing pressure. Solid lippings are pre-heated ina an attached pre-heater.
Technical caracteristic
Working length: 2600 mm.
Max workpiece thickness: 53 mm.
Solid lippings: up to 25 mm.
Total length of bander: 2740.
Machine height: 895 mm.
Air requierment per clamping operation: 25 l.
Pressure requierment: 6 atmg.
Edge pressure: 5 kg/cm2 for a length of 2500 mm, and thickness of 20 mm at 3,5 bar.
Heating: 220 V.
Connected load of the bander: 850 W.
For pre-heater: 850 W.
Heating up time to 100˚C: approx. 15 min.
Heating controlled by thermostat: from 40˚ to 150˚C.
Glue: PVAc white glue.
Machine weight: 230 kg.
Used, imported from Italy.
